MIL-DTL-3124E(SH)
6.7 Responsibility of prime mover manufacturer.
6.7.1 Capacity. The prime mover manufacturer should provide a prime mover of sufficient capacity to drive
the generator and exciter under all conditions of load and overload specified herein. Requirements for complete
prime mover-driven generator sets incorporating generators built in accordance with this specification are contained
in MIL-G-3087 if steam turbine-driven, MIL-G-21296 if diesel engine-driven, and MIL-G-22077 if gas
turbine-driven.
6.7.2 Parallel operation. The prime mover manufacturer should successfully demonstrate that angular variation
of the rotor of a diesel engine-driven generator due to torsional vibration will not interfere with successful
synchronizing of the generators.
6.8 Sub-contracted material and parts. The packaging requirements of referenced documents listed in section 2
do not apply when material and parts are acquired by the contractor for incorporation into the equipment and lose
their separate identity when the equipment is shipped.
6.9 Subject term (key word) listing.
Armature
Constant speed
Continuous duty
Exciter
Prime mover
Resistance temperature sensing element
Rotor
6.10 Changes from previous issue. Marginal notations are not used in this revision to identify changes with
respect to the previous issue due to the extent of the changes.
Preparing Activity:
Navy SH
(Project 6115-2011-001)
NOTE: The activities listed above were interested in this document as of the date of this document. Since
organizations and responsibilities can change, you should verify the currency of the information above using the
ASSIST Online database at https://assist.dla.mil.
32
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business