MI L-DTL-53133/ 5B
change above and below the new steady-state frequency (undershoot) shall be not
more than 4 percent of rated frequency.
3.12 Frequency adjustment. By means of the frequency adjust device, it shall be
possible to adjust the frequency, (when the set is operating at any constant load) as
follows:
- Between 58 and 62 but not above 65 Hz for the 60 Hz operating condition.
- Between 48 and 52 but not below 45 Hz for the 50 Hz operating condition.
I t shall not be possible to adjust the frequency for operation within the 48 to 52 Hz
range when the frequency selector switch is in the 60 Hz position; and it shall not be
possible to adjust for operation in the 58 to 62 Hz range when the frequency selector
switch is in the 50 Hz position. Further, it shall not be possible to adjust frequency to a
value which will actuate the overspeed protective device.
3.13 Voltage waveform. The deviation factor for the line-to-line and line-to-neutral
voltage waveform for each voltage connection shall be not more than 5 percent, nor
shall any single voltage harmonic be more than 2 percent. I n addition, there shall be
no evident discontinuities, spikes, or notches in the waveform when viewed on an
oscilloscope having a bandwidth of DC to 1.5 MHz and usable viewing screen of 8 x 10
cm. The oscilloscope gain shall be adjusted such that one cycle of voltage wave covers
approximately the entire viewing screen.
3.14 Voltage unbalance. Maximum difference between line-to-line voltages shall be
not more than 5 percent of rated voltage for the 240/ 416-volt connection under the
conditions of a single phase, line-to-line unity pf-load of 25 percent rated current and
no other load on the generator.
3.15 Phase balance voltage. With the set operating at rated voltage and frequency
and no load, maximum difference in the three line-to-neutral voltages shall be not more
than 1 percent of the rated line-to-neutral voltage. The maximum difference between
the voltage of the 120-volt windings of any phase shall not exceed 1 volt.
3.16 Voltage modulation. The voltage modulation of the output voltage for any load
up to and including rated load shall not exceed 1 percent. This requirements shall apply
to all line-to-line and line-to-neutral voltages.
3.17 Voltage regulation. The voltage regulation from no load to rated load and from
rated load to no load shall be not more than 1 percent of the rated voltage for all
voltage connections throughout the voltage ranges specified in 3.22.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business