MIL-DTL-3124E(SH)
ASTM A976
-
Standard Classification of Insulating Coatings for Electrical Steels by
Composition, Relative Insulating Ability and Application
ASTM B23
-
Standard Specification for White Metal Bearing Alloys
ASTM B26/B26M
-
Standard Specification for Aluminum-Alloy Sand Castings
ASTM B209
-
Standard Specification for Aluminum and Aluminum-Alloy Sheet and
Plate
ASTM B700
-
Standard Specification for Electrodeposited Coatings of Silver for
Engineering Use
ASTM D5948
-
Standard Specification for Molding Compounds, Thermosetting
ASTM E208
-
Standard Test Method for Conducting Drop-Weight Test to Determine
Nil-Ductility Transition Temperature of Ferritic Steels
(Copies of these documents are available online at www.astm.org.)
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)/NATIONAL ELECTRICAL
MANUFACTURERS ASSOCIATION (NEMA)
ANSI/NEMA MW 1000
-
Magnet Wire
(Copies of this document are available online at www.nema.org.)
INSTITUTE OF ELECTRICAL AND ELECTRONICS ENGINEERS (IEEE)
IEEE 115
-
Guide for Test Procedures for Synchronous Machines
(Copies of this document are available online at www.ieee.org.)
SAE INTERNATIONAL
SAE-AS50151
-
Connectors, Electrical, Circular Threaded, AN Type, General Specification for
Connections for General Use and Fluid Power Ports and Stud Ends
SAE-J1926/1
-
(Copies of these documents are available online at www.sae.org.)
UNDERWRITERS LABORATORIES INC. (UL)
Standard for Systems of Insulating Materials General
UL 1446
-
(Copies of this document are available online at https://www.ul.com.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict between
the text of this document and the references cited herein, the text of this document takes precedence. Nothing in this
document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 First article. When specified (see 6.2), a sample shall be subjected to first article inspection in accordance
with 4.3.
3.2.1 Material requirements. The requirements for materials to be used in the generator shall be as specified in
table I. The requirements for wire sizes shall be as specified in table I below or in accordance with MIL-E-917.
Use of other wire sizes shall be approved in accordance with the procedures specified in MIL-E-917. Materials
other than those listed below may be used with NAVSEA approval.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business